bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Damon Challenger Motorhome


  • Atwood LP Gas and Carbon Monoxide Detector Indicator Lights Flashing Red and Yellow
  • You will most likely need to replace your Atwood carbon monoxide/LP gas detector # AT36681. It has a 7-year lifespan and if it has been in service longer than that it may not function properly. There are several things that the flashing lights could indicate: Power visual indicator flashing means the detector's power supply voltage is too high or too low. Carbon Monoxide indicator flashing means the CO alarm is disabled because the alarm is resetting or stabilizing OR the unit has gone...
    view full answer...

  • Troubleshooting A Non-Working Leveling System On A 2009 Damon Challenger 377 Motorhome
  • Typically when the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC358590 is malfunctioning it just needs a Zero Point Calibration Reset. It sounds to me like you may have already done this though so the next step is to check the power and ground to ensure that the system has what it needs to properly function. When I spoke to Lippert in the past their tech stated that the system requires 12.75v to properly operate. I recommend checking the controller with a multimeter...
    view full answer...

  • RV Ladder Solution for 2004 Damon Challenger
  • The simplest solution would be a telescoping ladder like the part # TE74FR that you referenced. This would store in your RV's storage compartment and would get pulled out and used when needed. This obviously doesn't require any installation so it's basically ready to be used as soon as you get it. For a more traditional RV ladder we have the Surco part # SP501L which permanently attaches to the rear of the RV. It will need to attach to studs on the roof and on the side wall of the RV.
    view full answer...

  • Replacement Control Brain For Lippert 4-Point System On A 2008 Damon Challenger
  • The # LC53ED is the correct replacement control brain for the Lippert 4 point leveling system on your motorhome. It is essentially the same controller for ALL Lippert 4-point leveling systems. This leveling system is common on fifth wheels, but we also see the same system on motorhomes just like your 2008 Damon Challenger. We also offer the control panel # LC175225, and brain wiring harness # LC178278 if yours are in need of replacement.
    view full answer...

  • Are There Replacements For A Discontinued Atwood Leveleg System
  • Since this system is discontinued you'd be looking at completely replacing the system with another unfortunately. Lippert does have some systems that are a similar design to your Atwood system and compatible with a motorhome layout, but we do not currently offer them. The only leveling systems that we currently offer for your 2008 Damon Challenger motorhome would be ones like the Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors # UF39-941705. This style stabilizer would mount...
    view full answer...

  • Finding a replacement wiper bulb seal that is 15 feet long for motorhome slideout
  • The closest thing available would be the Rubber Wiper Seal and Bulb for RV Slide Out - Stick On - 15' Long x 3-3/16" Wide # SR98FR. This is a 15 foot long bulb seal as you were needing and it applies to the surface by means of 3m adhesive backing. One thing to take into consideration is that the seal is 3-3/16" tall instead of the 4" that you were looking for. I would measure and make sure this will cover enough area on your slide out. If after measuring you find that this won't work for...
    view full answer...

  • How to Determine the Correct Electric Steps for a 2010 Damon Challenger Motorhome
  • We do have automatic (electric steps) available, but we do not carry full door replacements for motorhomes. Unfortunately, I need more information to recommend the correct option. You need to know your entry height and bracket width to determine the correct steps. For example, the Kwikee Electric RV Step Complete Assembly # LC372261 fits an entry height between 20-1/8" - 22-1/8" and has a bracket width of 25-1/2".
    view full answer...